#------------------------------------------------------------------------------
#
#  EtherCAT sysconfig file
#
#  $Id$
#
#------------------------------------------------------------------------------

#
#  PCI index of the (RTL8139-)EtherCAT device
#  Setting this is mandatory for the EtherCAT init script!
#
#DEVICE_INDEX=99

#
#  Number of Ethernet-over-EtherCAT interfaces every master shall create
#  on startup. Default is 0.
#
#EOE_INTERFACES=0

#
#  Bridge all EoE interfaces after master startup
#  This variable shall contain the name of the EoE bridge to set up.
#  If the variable is empty or undefined, no EoE bridge will be built.
#
#EOE_BRIDGE=eoebr0

#
#  IP address of the EoE bridge
#  Set both EOE_IP_ADDRESS and EOE_IP_NETMASK to let the local host communicate
#  with devices on the EoE bridge.
#
#EOE_IP_ADDRESS=192.168.X.X

#
#  IP netmask of the EoE bridge
#  See EOE_IP_ADDRESS.
#
#EOE_IP_NETMASK=255.255.255.0

#
#  Renew default gateway after bridge installation.
#  Set this to the new default gateway, if the default route shall
#  be renewed after the bridge has been installed.
#
#EOE_GATEWAY=192.168.X.X

#
#  List of extra interfaces to include in the EoE bridge.
#  Set this to interconnect the EoE bridge with other local interfaces.
#  If EOE_BRIDGE is empty or undefined, setting this variable has no effect.
#  Important: The IP address of these interfaces will be cleared. Set
#  EOE_IP_ADDRESS and EOE_IP_NETMASK accordingly to enable IP traffic to
#  extra interfaces.
#
#EOE_EXTRA_INTERFACES=eth0

#------------------------------------------------------------------------------