--- a/ethercat.sh Thu May 18 12:35:47 2006 +0000
+++ b/ethercat.sh Thu May 18 12:45:32 2006 +0000
@@ -2,7 +2,7 @@
#------------------------------------------------------------------------------
#
-# EtherCAT rc script
+# Init script for EtherCAT
#
# $Id$
#
@@ -36,14 +36,14 @@
#------------------------------------------------------------------------------
### BEGIN INIT INFO
-# Provides: EtherCAT
+# Provides: IgH EtherCAT master
# Required-Start: $local_fs $syslog $network
# Should-Start: $time
# Required-Stop: $local_fs $syslog $network
# Should-Stop: $time
# Default-Start: 3 5
# Default-Stop: 0 1 2 6
-# Short-Description: EtherCAT master driver and network device
+# Short-Description: IgH EtherCAT master modules
# Description:
### END INIT INFO
@@ -59,44 +59,13 @@
#------------------------------------------------------------------------------
-# Shell functions sourced from /etc/rc.status:
-# rc_check check and set local and overall rc status
-# rc_status check and set local and overall rc status
-# rc_status -v be verbose in local rc status and clear it afterwards
-# rc_status -v -r ditto and clear both the local and overall rc status
-# rc_status -s display "skipped" and exit with status 3
-# rc_status -u display "unused" and exit with status 3
-# rc_failed set local and overall rc status to failed
-# rc_failed <num> set local and overall rc status to <num>
-# rc_reset clear both the local and overall rc status
-# rc_exit exit appropriate to overall rc status
-# rc_active checks whether a service is activated by symlinks
. /etc/rc.status
-
-# Reset status of this service
rc_reset
-# Return values acc. to LSB for all commands but status:
-# 0 - success
-# 1 - generic or unspecified error
-# 2 - invalid or excess argument(s)
-# 3 - unimplemented feature (e.g. "reload")
-# 4 - user had insufficient privileges
-# 5 - program is not installed
-# 6 - program is not configured
-# 7 - program is not running
-# 8--199 - reserved (8--99 LSB, 100--149 distrib, 150--199 appl)
-#
-# Note that starting an already running service, stopping
-# or restarting a not-running service as well as the restart
-# with force-reload (in case signaling is not supported) are
-# considered a success.
-
case "$1" in
start)
echo -n "Starting EtherCAT master... "
- # remove incompatible modules
for mod in 8139too 8139cp; do
if lsmod | grep "^$mod " > /dev/null; then
if ! rmmod $mod; then
@@ -142,14 +111,6 @@
status)
echo -n "Checking for EtherCAT... "
- # Return value is slightly different for the status command:
- # 0 - service up and running
- # 1 - service dead, but /var/run/ pid file exists
- # 2 - service dead, but /var/lock/ lock file exists
- # 3 - service not running (unused)
- # 4 - service status unknown :-(
- # 5--199 reserved (5--99 LSB, 100--149 distro, 150--199 appl.)
-
lsmod | grep "^ec_master " > /dev/null
master_running=$?
lsmod | grep "^ec_8139too " > /dev/null