nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: Connecting to the CAN network : nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210:
nico@210: nico@210: next nico@210: nico@210: up nico@210: nico@210: previous nico@210: nico@210: contents nico@210:
nico@210: Next: starting the node : nico@210: Up: Running a HCS12 node nico@210: Previous: Connecting to a serial nico@210:   Contents nico@210:
nico@210:
nico@210: nico@210: nico@210:

nico@210: Connecting to the CAN network : nico@210:

nico@210: Connect the port CAN0 (pin PM0, PM1) to the network via a CAN nico@210: controller. On our board, the CAN controler is a PCA82C250 chip. nico@210: nico@210:

nico@210:

nico@210:
nico@210: epimerde nico@210: 2007-06-05 nico@210:
nico@210: nico@210: