nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: Connecting to a serial RS232 console : nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210:
nico@210: nico@210: next nico@210: nico@210: up nico@210: nico@210: previous nico@210: nico@210: contents nico@210:
nico@210: Next: Connecting to the CAN nico@210: Up: Running a HCS12 node nico@210: Previous: Flashing the memory : nico@210:   Contents nico@210:
nico@210:
nico@210: nico@210: nico@210:

nico@210: Connecting to a serial RS232 console : nico@210:

nico@210: Connect the portS(TxD0) of the HCS12 to a console configured at 19200 nico@210: bauds 8N1, via a Max232 chip to adapt the electricals levels. On Linux, nico@210: you can use minicom. Connecting to a console is usefull to read the nico@210: messages, but not required. nico@210: nico@210:

nico@210:

nico@210:
nico@210: epimerde nico@210: 2007-06-05 nico@210:
nico@210: nico@210: