#------------------------------------------------------------------------------ # # EtherCAT sysconfig file # # $Id$ # #------------------------------------------------------------------------------ # # PCI index of the (RTL8139-)EtherCAT device # Setting this is mandatory for the EtherCAT init script! # #DEVICE_INDEX=99 # # Number of Ethernet-over-EtherCAT interfaces every master shall create # on startup. Default is 0. # #EOE_INTERFACES=0 # # Bridge all EoE interfaces after master startup # This variable shall contain the name of the EoE bridge to set up. # If the variable is empty or undefined, no EoE bridge will be built. # #EOE_BRIDGE=eoebr0 # # IP address of the EoE bridge # Set both EOE_IP_ADDRESS and EOE_IP_NETMASK to let the local host communicate # with devices on the EoE bridge. # #EOE_IP_ADDRESS=192.168.X.X # # IP netmask of the EoE bridge # See EOE_IP_ADDRESS. # #EOE_IP_NETMASK=255.255.255.0 # # Renew default gateway after bridge installation. # Set this to the new default gateway, if the default route shall # be renewed after the bridge has been installed. # #EOE_GATEWAY=192.168.X.X # # List of extra interfaces to include in the EoE bridge. # Set this to interconnect the EoE bridge with other local interfaces. # If EOE_BRIDGE is empty or undefined, setting this variable has no effect. # Important: The IP address of these interfaces will be cleared. Set # EOE_IP_ADDRESS and EOE_IP_NETMASK accordingly to enable IP traffic to # extra interfaces. # #EOE_EXTRA_INTERFACES=eth0 #------------------------------------------------------------------------------