fp@250: #------------------------------------------------------------------------------ fp@250: # fp@250: # EtherCAT sysconfig file fp@250: # fp@250: # $Id$ fp@250: # fp@250: #------------------------------------------------------------------------------ fp@250: fp@250: # fp@250: # PCI index of the (RTL8139-)EtherCAT device fp@250: # Setting this is mandatory for the EtherCAT init script! fp@250: # fp@250: #DEVICE_INDEX=99 fp@250: fp@250: # fp@251: # Number of Ethernet-over-EtherCAT devices every master shall create fp@250: # on startup. Default is 0. fp@250: # fp@250: #EOE_DEVICES=0 fp@250: fp@283: # fp@283: # Bridge all EoE interfaces after master startup fp@283: # This variable shall contain the name of the EoE bridge to set up. fp@283: # If the variable is empty or undefined, no EoE bridge will be built. fp@283: # fp@283: #EOE_BRIDGE=eoebr0 fp@283: fp@283: # fp@283: # IP address of the EoE bridge fp@283: # Set both EOE_IP_ADDRESS and EOE_IP_NETMASK to let the local host communicate fp@283: # with devices on the EoE bridge. fp@283: # fp@283: #EOE_IP_ADDRESS=192.168.X.X fp@283: fp@283: # fp@283: # IP netmask of the EoE bridge fp@283: # See EOE_IP_ADDRESS. fp@283: # fp@283: #EOE_IP_NETMASK=255.255.255.0 fp@283: fp@283: # fp@285: # Renew default gateway after bridge installation. fp@285: # Set this to the new default gateway, if the default route shall fp@285: # be renewed after the bridge has been installed. fp@285: # fp@285: #EOE_GATEWAY=192.168.X.X fp@285: fp@285: # fp@283: # List of extra interfaces to include in the EoE bridge. fp@283: # Set this to interconnect the EoE bridge with other local interfaces. fp@283: # If EOE_BRIDGE is empty or undefined, setting this variable has no effect. fp@283: # Important: The IP address of these interfaces will be cleared. Set fp@283: # EOE_IP_ADDRESS and EOE_IP_NETMASK accordingly to enable IP traffic to fp@283: # extra interfaces. fp@283: # fp@283: #EOE_EXTRA_INTERFACES=eth0 fp@283: fp@250: #------------------------------------------------------------------------------