nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: Virtual CAN interfaces (for test/debug) nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210:
nico@210: nico@210: next nico@210: nico@210: up nico@210: nico@210: previous nico@210: nico@210: contents nico@210:
nico@210: Next: Testing your CanFestival installation nico@210: Up: CAN devices nico@210: Previous: LinCan nico@210:   Contents nico@210:
nico@210:
nico@210: nico@210: nico@210:

nico@210: Virtual CAN interfaces (for test/debug) nico@210:

nico@210: Configure switch: nico@210: nico@210:

nico@210: -can=virtual nico@210: nico@210:

nico@210: Virtual CAN interface use Unix pipes to emulate a virtual CAN network. nico@210: Each message issued from a node is repeat to all other nodes. Currently nico@210: only works with nodes running in the same process, and does not support nico@210: work with Xenomai. nico@210: nico@210:

nico@210:

nico@210:
nico@210: epimerde nico@215: 2007-06-08 nico@210:
nico@210: nico@210: