nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: Flashing the memory : nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210:
nico@210: nico@210: next nico@210: nico@210: up nico@210: nico@210: previous nico@210: nico@210: contents nico@210:
nico@210: Next: Connecting to a serial nico@210: Up: Running a HCS12 node nico@210: Previous: Compiling and building an nico@210:   Contents nico@210:
nico@210:
nico@210: nico@210: nico@210:

nico@210: Flashing the memory : nico@210:

nico@210: Use your prefered loader ! If you are using a debugger Lauterbach, you nico@210: can load the bash file : trace32_flash_programmer.cmm. It loads nico@210: directly the elf file. nico@210: nico@210:

nico@210:

nico@210:
nico@210: epimerde nico@211: 2007-06-06 nico@210:
nico@210: nico@210: