nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: Requirements nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210:
nico@210: nico@210: next nico@210: nico@210: up nico@210: nico@210: previous nico@210: nico@210: contents nico@210:
nico@210: Next: Cygwin configuration and compilation nico@210: Up: CYGWIN nico@210: Previous: CYGWIN nico@210:   Contents nico@210:
nico@210:
nico@210: nico@210: nico@210:

nico@210: Requirements nico@210:

nico@210: Cygwin have to be installed with those packages : nico@210: nico@210:

nico@210: nico@210:

    nico@210:
  1. gcc nico@210:
    2. nico@210:
  2. unzip nico@210:
    3. nico@210:
  3. wget nico@210:
    4. nico@210:
  4. make nico@210:
    5. nico@210:
nico@210: Currently, the only supported CAN devices are PeakSystems ones, with nico@210: PcanLight driver and library. nico@210: nico@210:

nico@210: Please download driver at nico@210: http://www.peak-system.com/themen/download_gb.htmlhttp://www.peak-system.com/themen/download_gb.html nico@210: - follow instructions in order to install driver on your system. nico@210: nico@210:

nico@210: Install Cygwin as required, and the driver for your Peak CAN device. nico@210: nico@210:

nico@210: Open a Cygwin terminal, and follow those instructions: nico@210: nico@210:

nico@210:

nico@210:
nico@210: epimerde nico@211: 2007-06-06 nico@210:
nico@210: nico@210: