nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: Connecting to a serial RS232 console : nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210: nico@210:

nico@210: Connecting to a serial RS232 console : nico@210:

nico@210: Connect the portS(TxD0) of the HCS12 to a console configured at 19200 nico@210: bauds 8N1, via a Max232 chip to adapt the electricals levels. On Linux, nico@210: you can use minicom. Connecting to a console is usefull to read the nico@210: messages, but not required. nico@210: nico@210:

nico@210:


nico@210:
nico@210: epimerde nico@211: 2007-06-06 nico@210:
nico@210: nico@210: