can_baudparams_t Struct Reference

#include <lincan.h>

Data Fields
long	flags
long	baudrate
long	sjw
long	sample_pt

---

Detailed Description

struct can_baudparams_t - datatype for calling CONF_BAUDPARAMS IOCTL : reserved for additional flags for chip configuration, should be written -1 or 0 : baud rate in Hz : synchronization jump width (0-3) prescaled clock cycles : sample point in % (0-100) sets (TSEG1+1)/(TSEG1+TSEG2+2) ratio

The structure is used to configure new set of parameters into CAN controller chip. If default value of some field should be preserved, fill field by value -1.

Definition at line 49 of file lincan.h.

---

Field Documentation

long can_baudparams_t::flags

Definition at line 50 of file lincan.h.

long can_baudparams_t::baudrate

Definition at line 51 of file lincan.h.

long can_baudparams_t::sjw

Definition at line 52 of file lincan.h.

long can_baudparams_t::sample_pt

Definition at line 53 of file lincan.h.

---

The documentation for this struct was generated from the following file:

• drivers/can_lincan/lincan.h

---